KIT CONTENTS : KNAELL/THREADER2

    1) In Bag :
        1. Nut Plate w. 1/4-28 Slipnut and #10-24 Socket Head Mounting Screw
        2. V-belt Pulley with 3/4" Clamp Collar
        3. Drill Guide/Leadscrew Pivot
        4. 16T Pulley and Companion 48T Timing Belt
        5. 32T Pulley and Companion 56T Timing Belt
        6. 1/16" Hex Key for #6-32 Nut Plate Tripod Screws
        7. 3/32" Hex Key for #10-24 Pulley Set Screws
        8. 7/64" Hex Key for #6-32 Nut Clamp(2 ea.)
        9. 5/32" Long Hex Key for 5/8" Collar
        10. 3/16" Long Hex Key for 3/4" Collar
        11. 24" Length of "#26Ga" Wire(0.0181"Dia. Measured)
        12. 24" Length of "#22Ga" Wire(0.0355"Dia. Measured)
        13 1/4" ID Shaft Clamp Coller

    2) In Bundle :
        1. 1/4-20 leadscrew with attached 1/4-20 "Slipnut"
        2. 10" Length of 1/4"Dia 1018 round cold rolled
        2. 10" Length of 1/4"Dia 1018 round cold rolled w. prep’d end
        4. 10" Length of 1/8"Dia. 12L14 round cold rolled
        5. 5" Length of 5/16"Dia. round brass for SlipNuts
        6. 5" Length of 1/8"Dia Water Hardening Drill Rod for Taps
        7. 5" Length of #4-40 steel Allthread

    3) Loose In Box :
        1. Above Bag and Bundle and this Sheet and Packing Material
        2. Headstock End Leadscrew Bearing Block Assembly
        3. Manual Crank with 5/8" Clamp Collar
        4. Spindle Extension with attached 16T "XL" Timing Pulley

* * * * * * * * * * * * * * * * * * *
       Will Also Need :
        1. A #26 Twist Drill and a #10-24TPI Tap and associated tools to mount the
            Nut-Plate-Assembly to the Lathe Carriage.

        2. Lathe tooling (incl.#1&#2 centerdrill) and Soldering Equipment to fabricate leadscrews as needed.

        3. 1/4" Square Lathe Toolbit and Bench Grinder to make"Long Reach"
            Grooving Tool for "Snap-Out" Handwheel Modification.
            (See Threader 1 Website)